What Is Crown Molding On The Floor Called

Stair steps photo by wendell t.

What is crown molding on the floor called. The floor lamp is very large and the wall covering has a large scale pattern. Sometimes called cornices crown molding dates back to ancient greece where craftsmen and builders chiseled ornate moldings from travertine stone or molded them from plaster. Molding is a general term used for any type of trim inside a home but ceiling molding generally falls under the term crown molding millwork on the other hand refers to anything that s been milled from wood it can mean molding baseboards built ins cabinetry and more.

Crown molding crown molding also called ceiling or cornice molding is the transitional piece between the wall and the ceiling. It may be used as a crown around the ceiling or on the inside of a vertical corner as a corner guard. Crown molding is typically in proportion to the baseboard molding.

Molding used around the floor of a room is called a baseboard is generally flat with only one unfinished side. It is also not as heavily ornate as the previous molding which is good because the pattern doesn t fight agains the pattern. Yes the angles on the edge of crown molding are 52 and 38 deg normally the crown molding extends further onto the ceiling than down the wall.

Often combined with crown molding this type of molding is one or two inches tall and appears seven to nine feet off the floor. If you need to mount it with the top side down and wish to maintain the same aspect ratio then you could re cut the edges. Anything smaller would have been too wimpy for this room.

Also called cornice moulding it s used to cover the intersection where the walls and the ceiling meet usually over a large angle. For traditional homes the rule of thumb is the taller the baseboard the taller the crown. 4 inch high 175 about 19 25 per linear foot.

Using a starter or riser molding in conjunction with a crown molding also provides the ability to better disguise an uneven ceiling as one end of the crown molding may be mounted. Crown moulding is always installed sprung angled. A starter or riser molding is mounted to the cabinet top in order to simulate an extension of the cabinet box allowing the crown molding to be installed higher.